|
|
|
|
|
Introduction During my recent trips to Europe as well as visits to various gardens throughout North America, I have watched with interest the resurgence of the use of Cannas in the contemporary landscape. Originally, this old fashioned Victorian bedding plant was used primarily in geometrically designed gardens. It then fell out of favour. In recent years however, this plant has made a tremendous comeback primarily because of the introduction of many hybrids that are compact in growth, floriferous, and easy to grow.
Planning
Considerations Prior to purchasing any started plants or tubers from a nursery, make sure that a planting plan is prepared to fully capitalize on the combination of flower and foliage variations as well as a wide range of heights that vary from 2½ to 8 feet. Remember that, “Simplicity is the Essence of Design”. Refer back to previous article in the Hort-Pro Archives on the Principles and Elements of Design for further information on this topic. Cultivars
Available Some of the good cultivars available include:
Over Wintering
Cannas are hardy in zones 7 to 11. Elsewhere it is necessary to remove tubers after frost has blackened the foliage. It’s important to keep the soil around the tubers during storage. To facilitate this, moisten the soil around the base of the plants prior to digging. This helps to prevent the tubers from drying out during winter storage. Once the plants are dug out, stocks should be cut back to 3” and tubers should be carefully labelled at this time. Any surface leaves or debris should be removed from the clumps of soil. Place the tubers in plastic crates lined with newspapers with about 1” of peat moss on the bottom of the container. Some gardeners like to use clean dry perlite, vermiculite, sharp sand, or even clean powder-dry soil. Dust with powdered sulphur and cover the clumps of tubers with peat moss. Store at 40 to 50 Degrees F in an area that has low humidity and good air circulation. Periodically check the tubers to make sure that they have not dried out. Water lightly if necessary. During the middle of February, clumps should be removed from the peat moss and separated into individual plants. Remove soil from the clumps and physically separate the tubers from each other. Leave several buds or eyes (2 or 3) on each tuber for best results. Place individual plants back in the plastic crates in a BM6 soil mixture. Fill the crates half full with BM6 and place the tubers on this material. Sprinkle with sulphur once again and cover with BM6. Firm the sides and place in 65 Degrees F temperature. Give tubers a good initial soaking and allow BM6 mixture to dry out. Water sparingly thereafter, as Cannas don’t enjoy being over watered. In three to four weeks, tubers should be ready for potting into 6” pots.
Now is the time to plan for this coming season’s endless combinations of Cannas. There are many different design possibilities and any good gardener should always look for new and exciting colour combinations. It you haven’t tried Cannas in your landscape in the past, try some this summer. You won’t be disappointed with the results.
John
A Morley Editor Hort-Pro |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Current Issue
